Sunrise Medical Zippie Z-Bop Bedienungsanleitung Seite 10
- Seite / 88
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
932213 Rev. C
10
ENGLISH
VI.
U. WHEELCHAIR LIFTS
WARNING
Wheelchair lifts are used in vans, buses, and buildings to
help you move from one level to another.
1.
Always turn off all power to your chair when you are on a
lift. If you fail to do so, you may touch the joystick by acci
-
dent and cause your chair to drive off the platform. (Be
aware that a “roll-stop” at the end of the platform may not
prevent this).
2.
Make sure there is not a lip or drop-off at the top or bottom
of the platform. These may cause a fall or tip-over. When in
doubt, have someone help you.
3. Always secure the rider with a positioning belt to help pre-
vent falls during transfers.
4. Avoid moving forward if a wheel is “hung up” on the lip of
the ramp. Backup, reposition the caster for a more direct
approach and slowly try again.
V. CURBS & SINGLE STEPS
WARNING
1. It is recommended to climb and/or descend a curb, single step,
or other obstacle that a ramp or curb cutout is always used.
2. If you must climb or descend a curb, single step, or other
obstacle that is greater than 2.5", it is recommended to have
a person assist you in doing so.
3. In no case should you try to climb a curb, single step, or
other obstacle greater than 4" high.
4. If you must climb or descend a curb or step alone do so at
your own risk using extreme care and follow the following
procedure:
• Proceed slowly, at a steady speed
• Go as straight up or down as you can over the obstacle.
Never turn when trying to climb or descend and obstacle,
doing so may result in a fall or tip-over.
5. Failure to follow the above procedures may cause:
• A Fall or Tip Over
• Damage to the frame, wheels, axles or other parts, or
loose fasteners.
W. STAIRS
WARNING
Never use this chair to go up or down stairs, even with
an attendant. Doing so is likely to cause a fall or tip-over.
X. ESCALATORS
WARNING
Never take this chair on an escalator
, even with an
attendant. Doing so is likely to cause a fall or tip-
over
.
R. RAMPS, SLOPES & SIDEHILLS
WARNING
The center of balance of your chair changes when you
are on a slope.
Q-NOTE– “Slope” includes a ramp or sidehill. Your chair is less stable
when it is at an angle. Never use this chair on a slope unless you are
sure it is safe. When in doubt, have someone help you.
Beware Of:
1. Steep slopes. Do Not use this chair on a slope steeper than
10%. (A 10% slope means one foot in elevation for every
ten feet of slope length.)
2. Wet or slippery surfaces (such as when ice, snow, water or oil
film is present). A loss of traction may cause a fall or tip-over.
3. A change in grade on a slope (or a lip, bump or depression).
These may cause a fall or tip-over.
4. A drop-off at the bottom of a slope. (A drop-off of as small
as 3/4 inch can stop a front caster and cause the chair to tip
forward).
S. TO REDUCE THE RISK OF A FALL, TIP-
OVER OR LOSS OF CONTROL
WARNING
1. Never use your chair on a slope unless you are sure you can
do so without losing traction.
2. Always go as straight up and as straight down as you can.
• Do not “cut the corner” on a slope or ramp.
• Do not turn or change direction on a slope.
3. Always stay in the center of the ramp. Make sure ramp is
wide enough that you are not at risk that a wheel may roll off
the side.
4. Lean or press your body uphill. This will help adjust for a
change in the center of balance caused by the slope.
5. Keep your chair moving at a slow, steady speed. Keep control
over the chair at all times.
• On a descent, do not let your chair accelerate beyond its
normal speed.
• If the chair picks up speed, center the joystick to slow
down or stop.
• If you stop, re-start slowly.
T. RAMPS AT HOME & WORK
WARNING
Make sure ramps meet all Building Codes for your area.
1. For your safety, have a licensed contractor build or remodel
ramp to meet all standards.
Q-NOTE– The proper design will vary, depending on such things as:
the length and height of the ramp; the need for an intermediate
platform; landing size; doors and the direction of swing; and whether
the ramp includes a turn or angle.
At A Minimum:
1. Open sides of ramp must have side rails to prevent your
chair from going over the edge.
2. Slope must not be steeper than one inch in height for every
one foot of slope length.
3. Ramp surface must be even, and have a non-skid surface.
4.
Y
ou may need to add a section at the top or bottom to avoid
a lip or drop-off.
5. Ramp must be sturdy. Add bracing if needed, so ramp does
not “bow
” when you ride on it.
- Improving People’s Lives 1
- II. TABLE OF CONTENTS 3
- III. YOUR CHAIR AND ITS PARTS 4
- Q-NOTE– Where they apply 5
- 932213 Rev. C 10
- (seat frame only) 12
- (Power base only) 12
- (optional) (Manual Carrier) 13
- TOOLS YOU WILL NEED 14
- (Figures 1, 2 & 3) 15
- (Seat Frame) 15
- E. CHECK-OUT 16
- D. POWER BASE SHROUD REMOVAL 16
- F. BACKREST 17
- M. 90º FOOTBOARD (Fig. 16) 18
- (Fig. 17) 19
- (Optional) (Fig. 18) 19
- (Figs 19, 20, 21, 22) 19
- (Fig. 23) 20
- (Optional) (Fig. 24) 20
- (Manual carrier) (Fig. 25) 20
- (Figs. 26 & 27) 20
- W. CHECK-OUT 21
- (Optional) 22
- E. THERMAL ROLL-BACK 23
- F. CIRCUIT BREAKERS 23
- G. JOYSTICK ASSEMBLY 23
- H. ENHANCED DISPLAY 24
- I. MOTOR LOCKS 24
- Refer to wiring diagram for 25
- J. TOOLS YOU WILL NEED 28
- G. MOTOR BRUSHES 28
- H. ORDERING PARTS 28
- I. MAINTENANCE CHART 28
- FRANÇAIS 30
- II. TABLE DES MATIÈRES 31
- ZIPPIE Z-BOP 32
- (fauteuil manuel uniquement) 40
- (en option) 42
- NOTES : 43
- AVERTISSEMENT 43
- OUTILLAGE REQUIS 43
- D. RETRAIT DE LA HOUSSE 45
- E. VÉRIFICATIONS 45
- F. DOSSIER 46
- (Fig. 12) 47
- (Fig. 13 & 14) 47
- (Fig. 15) 47
- (Fig. 16) 47
- (en option) (Fig. 18) 48
- (Fig. 19, 20, 21, 22) 48
- (Fig. 24) 49
- (Fauteuil manuel) 49
- (Fig. 25) 49
- Disjoncteur 50
- F. DISJONCTEURS 52
- G. LEVIER DE COMMANDE 52
- Reportez-vous au schéma 55
- À VÉRIFIER… 57
- II. ÍNDICE 60
- III. SU SILLA Y SUS PARTES 61
- (silla manual solamente) 68
- (bastidor de asiento 69
- (Base eléctrica solamente) 69
- U. TUBOS CONTRA VOLCADURAS 71
- ADVERTENCIA 71
- HERRAMIENTAS NECESARIAS 72
- (Base eléctrica) 73
- E. REVISIÓN 74
- F. RESPALDO 75
- (Figs. 13 y 14) 76
- (opcionales) 77
- (Fig. 18) 77
- (Figs. 19, 20, 21, 22) 77
- (Opcional) (Fig. 24) 78
- (Silla manual) 78
- (Figs. 26 y 27) 78
- Interruptor 79
- (Opcionales) 80
- F. INTERRUPTORES DE CIRCUITO 81
- H. PANTALLA OPTIMIZADA 82
- I. SEGUROS DEL MOTOR 82
- (BATERÍAS 83
- HÚMEDAS SIN SELLAR) 83
- Consulte el diagrama de 84
- REVISE 86
Verwandte Produkte und Handbücher für Nein Sunrise Medical Zippie Z-Bop
Nein Sunrise Medical Aspire F11 Bedienungsanleitung
(108 Seiten)
(108 Seiten)
Nein Sunrise Medical J2 Bedienungsanleitung
(8 Seiten)
(8 Seiten)
Nein Sunrise Medical LX Bedienungsanleitung
(1 Seiten)
(1 Seiten)
Nein Sunrise Medical 515A Bedienungsanleitung
(28 Seiten)
(28 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.115 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern